Orientation of orthotropic material properties in a femur FE model: A method based on the principal stresses directions Article

San Antonio, T, Ciaccia, M, Müller-Karger, C et al. (2012). Orientation of orthotropic material properties in a femur FE model: A method based on the principal stresses directions . MEDICAL ENGINEERING & PHYSICS, 34(7), 914-919. 10.1016/j.medengphy.2011.10.008

cited authors

  • San Antonio, T; Ciaccia, M; Müller-Karger, C; Casanova, E

authors

abstract

  • Most work done on bone simulation has modeled the tissue as inhomogeneous and isotropic even though it is a recognized anisotropic material. Some recent investigations have included orthotropic behavior in bone finite elements (FE) models; however the problem regarding the orientation of these properties along the irregular bone anatomy remains. In this work, a procedure to orientate orthotropic properties in a proximal femur FE model using the directions of the principal stresses produced by a physiological load scheme was developed. Two heterogeneous material models, one isotropic and one orthotropic, were employed to test their influence on the mechanical behavior of the bone model. In the developed orthotropic material, the mechanical properties are aligned with the highest principal stress produced from the successive application of a multi load scenario corresponding to 10%, 30% and 45% of the gait cycle. A solid match between anatomical structures in the proximal femur and the corresponding directions of the main principal stress of the elements of the model suggests that the developed methodology works accurately. The differences found in the stress distributions were small (maximum 7.6%); nevertheless the changes in the strain distributions were important (maximum 27%) and located in areas of clinical relevance. © 2011 IPEM.

publication date

  • September 1, 2012

published in

Digital Object Identifier (DOI)

start page

  • 914

end page

  • 919

volume

  • 34

issue

  • 7